SSH Connection

• Make sure you have enabled Root access before by following Enable Root Access section.

• Download and install the MobaXterm software: Here

• Launch it then click on the Session icon:

  

• Then on then SSH icon:

  

• Enter the IP address of your printer in the Remote Host field, check the Specify username box and enter the username root in the field then click on OK:

  

• On the new displayed window, enter the password creality_2023 (it's not displayed when typing, this is normal):

  

• An authorization window will appear, authorize it. It's also possible that another window asking you to change the password will appear, ignore it.

• Once connected, on the left part of the window you have access to the folders and files of your printer and on the right part to the SSH command prompt window:

  

If you like my work, don't hesitate to support me by paying me a 🍺 or a ☕. Thank you 🙂