Skip to content

Buzzer Support

This allows to use the buzzer integrated into the motherboard to play a sound during certain actions.

Note

This procedure must be repeated after restoring the printer to factory settings.

Installation

  • Make sure you have followed this Install Helper Script section before.

  • In the script, enter in [Install] Menu by typing 1 , validate with Enter and install Buzzer Support:

  • Then reboot your printer.

Configuration

  • You can use BEEP command where you want in macros to play a sound.

    Example

    Here is an example to play 3 sounds when printing is complete:

    gcode_macro.cfg
    [gcode_macro END_PRINT]
gcode:
  Qmode_exit
  EXCLUDE_OBJECT_RESET
  PRINT_PREPARE_CLEAR
  M220 S100
  SET_VELOCITY_LIMIT ACCEL=5000 ACCEL_TO_DECEL=2500
  TURN_OFF_HEATERS
  M107 P1
  M107 P2
  END_PRINT_POINT
  BEEP
  BEEP
  BEEP
  WAIT_TEMP_START
  M84


If you like my work, don't hesitate to support me by paying me a 🍺 or a ☕. Thank you 🙂