Skip to content

Easy Installer

Easy Installer allows you to install programs or perform some actions in an easy way.

  • To run it, connect to printer over SSH (see SSH Connection section).

  • In the SSH command prompt window, enter the following command to start Easy Installer:

    SSH Command Prompt
    easy-installer

    Install Menu

    Remove Menu

    Update Menu

    • 1) Update Klipper configuration files → This allows to update your printer with latest Klipper configuration files
    • 2) Printer Setup Wizard → This helps you to configure your printer with the desired features
    • 3) Update Motherboard MCU firmware → This allows to update Klipper firmware of motherboard when Katapult bootloader is installed
    • 4) Update MMB Cubic MCU firmware → This allows to update Klipper firmware of BigTreeTech MMB Cubic
    • 5) Update Debian packages → This allows to update installed packages from Debian repository

    Extras Menu

    • 1) Backup Klipper configuration files →This allows to backup Klipper configuration files to a backup_klipper.zip compressed file
    • 2) Restore Klipper configuration files → This allows to restore Klipper configuration files from a backup_klipper.zip compressed file
    • 3) Backup Moonraker database → This allows to backup Moonraker database to a backup_moonraker.zip compressed file
    • 4) Restore Moonraker database → This allows to restore Moonraker database from a backup_moonraker.zip compressed file
    • 5) Restore Web-UI default settings → This allows to restore the pre-configured settings of Mainsail and Fluidd Web interfaces
    • 6) Delete cache and logs files → This allows to delete temporary files and log files
    • 7) Extend storage partition → This allows to extend storage partition to take advantage of the full storage (microSD card or eMMC)


If you like my work, don't hesitate to support me by paying me a 🍺 or a ☕. Thank you 🙂