First Boot

  • Turn on the printer and you should see the "Open Source Edition" boot logo:

    If not, your image was not correctly written to your microSD card, try another microSD card or retry: Prepare microSD Card for FLSUN OS

  • Once you are on the KlipperScreen interface, click on Configurations → Network and connect to your WiFi network.
    Your local IP address should be displayed in the top right corner.

  • Wait for Moonraker and Klipper to connect, if not click Retry button.
    The LEDs on the left side of the screen should light up white as soon as the connection is established.

  • Then, restart the printer (this is important for the proper functioning of the OS).

  • Next, take a look to Klipper Configurations Files section.

  • Enjoy 😃

Warning

Don't forget to calibrate your printer before starting a print!

To do this, go to the Configurations → Calibrations menu.

  • Motors Calibration → To Calibrate Motors
  • Z Offset Calibration → To adjust Z Offset if needed
  • Bed Mesh → To perform Delta Calibration and Bed Leveling
  • Input Shaper → To measure Resonances


If you like my work, don't hesitate to support me by paying me a 🍺 or a ☕. Thank you 🙂